Italpresse Laboratory Press PDL

PDL – LABORATORY PRESS

• weld free ring frames, made with flame cut solid steel plates, calculated with high structural safety factor.
• the heating platens are obtained from solid steel plates, specially rolled, finely milled and smoothed on the surfaces. Platens are diagonally guided, for a precise flatness control on the panel
• pressing pistons are CNC ground, polished and chromed.
• up-stroke movement of the platens
• complete with all the relevant digital interfaces to set, control, change and save all the pressing cycles

MODEL PDL/50

• Platens dimensions mm. 500x500
• Loading side mm. 500
• Daylight mm. 600
• Cylinder run mm. 600
• Specific pressure on the 100% platen’s surface Kg/cm² 60
• Maximum thrust Ton. 150
• Max temperature °C 250
• Opening/closing speed mm/sec 75
• Installed power Kw 4

MODEL PDL/60

• Platens dimensions mm. 600x600
• Loading side mm. 600
• Daylight mm. 600
• Cylinder run mm. 600
• Specific pressure on the 100% platen’s surface Kg/cm² 100
• Maximum thrust Ton. 360
• Max temperature °C 250
• Opening/closing speed mm/sec 75
• Installed power Kw 5,5

OPTIONAL:

• High speed approach variable speed to reach the pressure
• Computer for the programming of the working cycle
• Electronic adjustment of the speed during the embossing cycle
• Embossing electronic control unit, complete with microprocessor “control 10/2”. To set and control the embossing quota.
• Separate electronic control of the platens temperature by digital instruments
• Digital manometer to control low and high embossing pressures.
• Grafic printer to show the temperatures and the pressures complete with transducer and power probe.
• Digital thermoregulator for the cooling cycle
• Thermoregulator oir heating/cooling unit mod. TM/OH 1012/45 – 12 KW